![]() (a) You may only use the SOFTWARE on a specific single computer at one time. ![]() Roland grants you the following non-exclusive rights to use the SOFTWARE in accordance with the terms of this License Agreement. By installing, copying, or starting the use of the SOFTWARE, you hereby consent to the terms of this License Agreement. Please read carefully the terms of this License Agreement before installing or using the SOFTWARE. This is a legal agreement between you (an individual or a corporation) and Roland Corporation (herein referred to as "Roland") regarding the usage of this software product (herein referred to as "SOFTWARE"). The foregoing provision is effective even if Roland Corporation has been advised of the possibility of such damages. In no event shall Roland Corporation be liable to end-users for any damages whatsoever, including but not limited to financial damages for any loss of profits or information arising from the use of, or inability to use this updater. * Never turn off the power while the performance pads are blinking alternately. When the restore operation finishes, all performance pads flash. The performance pads blink alternately, and then all performance pads blink. When copying is completed, operate your computer to eject the "Roland" drive.Copy the backup files into the "Roland" drive's "RESTORE" folder.On your computer, open the "Roland" drive.The SEQUENCER section's button blinks, and the performance pads blink. While holding down the mixer section's SAMPLER button, use a USB cable to connect the DJ-202 to your computer.This restores the backed-up data from the computer to the DJ-202. After the factory reset is complete, disconnect the USB cable to power-off the DJ-202.* Never turn off the power while the MASTER level indicator is blinking. When the factory reset finishes, all buttons and pads light up. Press the blinking button.įactory reset begins.While holding down the button in the left side (L channel) of the browser section, use a USB cable to connect the DJ-202 to your computer, and continue holding down the button until the SEQUENCER section’s button blinks.This returns all system settings, all patterns and kits (instruments) stored in the unit's memory to their factory defaults. Returning to the Factory Settings (Factory Reset) Disconnect the USB cable to power-off the DJ-202.ĭrag the "Roland" icon to the Trash icon in the Dock. Please refer to the "DJ-202 Owner's Manual" for detailed information in the. To update the TR-S, the operation in "Returning to the Factory Settings (Factory Reset)" is required after applying the update data.Įxecuting the operation in "Returning to the Factory Settings (Factory Reset)" enables you to load the most recent tone data. This is not a malfunction without turning off the power, wait for the unit to start up. * The performance pads might flash at the first startup after the update. Detach the USB cable and turn off the power.When the performance pads stay lighted, the update is complete. The performance pads flash while the update is in progress. Pressing the button in the mixer section starts the update.Copy DJ202-505_C0A_up.bin in the "dj202505_sys_112" folder into the "Roland" drive by dragging and dropping it.Open the "Roland" drive folder in your personal computer.While holding down the button in the mixer section, connect the DJ-202 and the computer using the USB cable and turn on the power.Please install the extracted system program file into your DJ-202 according to the following procedure. Otherwise the system program or the DJ-202 itself may be destroyed. Never turn off the DJ-202's power while the update is in progress.You must not rename the extracted file.Please open/extract the downloaded "dj202505_sys_112.zip" file on your computer to get the update file in the "dj202505_sys_112" folder.
0 Comments
Leave a Reply. |